HOW TO USE PH NEUTRAL SHAMPOO

Detail 1

  1. Fill wash bucket with 3 to 4 gallons of water and add approximately 1oz. of Reset as the bucket fills to mix the shampoo solution and activate the foam.

  2. Pre-rinse vehicle with freeflowing water to remove loose debris and wash out of direct sunlight from the top down using a soft microfiber towel, rinsing the towel periodically in a second bucket filled with clear water.

  3. Do not allow shampoo to dry on the surface! After washing, rinse the vehicle thoroughly with freeflowing water to remove shampoo residue, and dry with a Towel forced-air blower.

Detail

AFTER WASH CARE

Detail 3

  • Do not apply in direct sunlight.

  • Apply in good ambient lighting.

  • Shake well.

  • Spray 4-5 sprays onto a microfiber towel or directly on the paint and spread out left and right and then up and down over a 2 to 2.5 sq ft area.

Detail 4

  • Work it into the paint evenly until almost flashed away.

  • Flip towel and buff in further.

  • Switch to a fresh clean towel Buff the area once more to be sure no residue remains.

  • Check after each panel before moving to the next.